VW EDC15 IMMO OFF/ ON programs are a single use and they can only be used in one car! Note: For 14 pin socket in LT, the procedure is the same as 16 pin OBD socket. Turn off ignition and disconnect Julie Emulator. When the ignition turned, connect the emulator plug to emulator PCB.īlue LED will flash fast and after several seconds the LED should light constantly and blink every two seconds. How to use Julie Emulator to do IMMO OFF/ON VW EDC15?ĭisconnect plug with wires from Julie Emulator. Solve problem: Engine Control Module get blocked by immobilizer when connect ECU with a diagnostic interface or car start then die.In the case of losing your car keys, you will be able to drive to nearest car garage.Or once it connects to car OBD socket, the car key immo get removed.Julie Car Emulator replaces damaged immobilizer, instrument cluster.Program selection is effected by proper soldering of jumpers.īefore using this emulator, check if there is a connection between ECU and OBDII. Check below for more details!Įngine capacity: 1.2TDI, 1.4 TDI, 1.9 TDI, 2.5 TDI with W2 and W3 systems, diesel engines from 2000 to 2004, some to 2006, and even 2008 (except Audi with coded pump) Suitable for vehicles with 2-socket ECUs. I assume in this case that the security data pin/code is still on the eeprom for BSI coding.This is a how-to guide manual for Universal Julie Emulator VW EDC15 IMMO OFF/ IMMO ON function. So what are the impacts on the BSI? Does the three connector ECU use the flash to check the security code/pin, or the eeprom?ĭoes this mean if you write a different file to the flash on any PSA three connector ECU then the immobiliser won't work? Ie, you'd need to always edit the original file if remapping? Three connector sounds like it has coding for immo/security on the eeprom in an encoded form, which can be decoded to then be able to be written to the flash (if you need to) Single connector had coding for immo/security data on the eeprom. I'm a little confused about how the PIN is stored and used from single connector to three connector ECU's. So the eeprom contains data that is checked against the flash, so the data in the eeprom is like a checksum for the flash data too? If you just wont to adapt keys for PSA group PIN can be calculated from eeprom - PIN can be programed to the ECU.

Tihiuvek wrote:If it is EDC15C2 Ecu with 3 connectors immo can be removed only in flash (AMD29F400BT) all other EDC15 can be done in eeprom (95160, 95P08.).

Edc15 immo off